Fully floating rear axle for Lada

The idea is to create fully floating rear axle for Lada, that will be extremely stiff, lightweight, allow adjustment of toe and camber and will be direct fit.
Currently I have the hubs finished, Soon I will get the whole axle done. The purple part will be welded to the sleeves of the axle. Two tapered bearing will be mounted on it and the hub over them. This way all the loads from the road surface will be driven into the axle housing. This allows the drive shaft(in green), to transmit only the drive torque. This is the basic idea. More when I am done with the whole model.

The hub with the brake caliper

Partial section view, showing the internals

Full section view, further showing the internal arrangement